Leibinger JET3 up - Counter Increment (Methods); Figure 171 - Counter Settings - Increment Methods

Page 324 Job Editor Group 8
Release R1.06 JET3up

Reset2 on X4: The reset happens by an external supplied signal on the X4
interface. The actual input has to be assigned in the I/O Settings dialog box
(Settings – I/O Settings – Inputs)

A counter reset method can be assigned to more than one counter. Therefore it
is possible to create “Reset groups”.
Example for “Reset groups” – 6 defined Counters assigned to three groups
Counter
Counter
1
Counter 2
Counter 3
Counter 4
Counter 5
Counter 6
Reset
Assignment
external
external
Reset1 on
X4
Reset1 on
X4
Reset2 on
X4
Reset2 on
X4
Pin
Assignment
X4
X 4.1 fixed
6 available inputs for
free assignment
6 available inputs for
free assignment
8.7.3.1.11 Counter increment (methods)
With the drop-down list <Counter Increment> you can determine the method at
which event the counter value should be changed (incremented or decremented).
Figure 171 Counter settings - Increment methods

with PrintGo:
The change in value of the counter happened with each the PrintGo-signal
(even, if the printout
is stopped and the printer still receives some PrintGos from
the sensor or the internal PG source).
 with printing (text) end:
The change in value of the counter happens after the printout was made.
 Extern (external signal):
The change in value happens by an external signal (interface X4).