Page 138 Job Editor Group 8
Release R1.06 JET3up
If this check box is selected the printer will start from the stand-by mode with one
touch to the Print Stop mode. The boot sequence looks as follows:
1. Booting the printer software
2. Initialization
3. Bleeding
4. Open nozzle
5. Print Stop
Activate warning messages for log file memory
If this check box is selected there will warning messages pop up when 95% of the
data logging memory is filled. Please see chapter 7.4.5Data logging - Log file
details about data logging.
7.3.1.6 IP-Address
The tab <IP-Address> (2) provides the settings for the IP-Address of the device.
In order to integrate the LEIBINGER JET3up printer in a network based on the
internet protocol an IP-address has to be assigned to the device.
The assignment of the IP-
address can be either done manually or automatically by
using a DHCP server.
Together with the IP-address the subnet mask (4) and the IP-
gateway (5) have to be specified.
The LEIBINGER JET3up printer offers to use a network path
this option is used the IP addresses of the DNS (8) and the WNS (9)
also to be specified. For details about the network path
options please see chapter
7.3.1.7 Network ID.
Select the <IP-Address> (2) tab.
Click on a address block to be changed.
Address blocks are separated by dots.
E.g. the IP-address consists of 4 address blocks (4)
and each block has a value
between 0 and 255. A numeric keypad (10) opens for input.
with the return key of the numeric keypad (11).
Now carry out the settings for every further address block accordingly.
The subnet mask (4), the IP address for the standard gateway (5)
the network path option is used, the addresses for the DNS (8) and WINS (9)
are set in the same way.
Alternative proceeding: with the option “Obtain an IP address via DHCP” (7)
IP address of the LEIBINGER JET3up printer is assigned automatically by DHCP.
To Next Page
