Group 5 Transport/Start up Page 51
JET3up Release R1.06
5.4.2 Fill reservoir tank - Step 2
To avoid damages of the device during the transportation the reservoir tanks should be
evacuated and have to be filled before the initial operation.
WARNING
Before filling the device with the consumables, measures for the
electrostatic discharge have to be made!
The operator can car
ry out a discharge either by the direct touching
of the JET3UP-cabinet or by standing with the appropriate ESD-shoes
on an grounded surface!
WARNING
Dangerous material in the machine!
Danger of serious damage through burns, skin irriation and
poisoning!
Protective equipment is necessary!
Read the safety data sheets
and the personal protective equipment rules and regulations!
The reservoir tanks for ink and solvent are installed beneath the cover flap of the refill
unit. T
he two reservoir tanks are monitored by level sensors. They are always
unpressurized and can be opened in every device condition.
The reservoir tanks and the sealing cap are color-
coded and labelled to avoid any
mistakes in filling. Additionally the sealing caps are marked with the ink-no. or solvent-
no. which are admissible for the device. For correct handling the LEIBINGER re-
system allows an odor- and splash free refilling of the consumables.
Use only genuine LEIBINGER solvent and ink that comes with a TAG on
the refill bottle!
The JET3up printer is supplied with a TAG Reader. For refills of solvent or
ink make sure that only genuine LEIBINGER ink and solvent is used. Only
then the refill bottles will have TAG. The TAG has to be r
TAG reader of the JET3up before filling up the reservoir tanks!
Please see chapter 10.1.2 TAG-reader for details about the TAG reader!
To Next Page
Loading...
