Group 5 Transport/Start up Page 41
JET3up Release R1.06
5 Transport/Start up
5.1 Transport, storage, shipping
In order to avoid damage during transport the following instructions must be
observed.
The LEIBINGER JET3up must only be transported in a standing position. It is packed
in a cardboard box with special polystyrene inserts for safe dispatch during delivery.
Transport of the device must only be made in this packing in order to avoid damage.
The printer should be only transported in an empty condition! A
special draining routine (“ServiceFunctions Hydraulic Special
Functions/ Tools Drain Routine“) is available for the draining of the
device.
Note!
Storage temperatures below +5°C and above +50°C as well
as storage at outside are not admissible and can lead to damage!
5.2 Mounting
The device must not be operated in potentially explosive areas!
The installation has to be carried out according to the installation
instructions of the manufacturer!
Precautions regarding electrostatics have to be carried out!
WARNING – INSTALLATION OF THE DEVICE
The device must be installed in a well ventilated room only and must
be kept away from any source of heat, flame or sparks, e.g. radiant
heater, etc.!
Check device for damage! When determining a suitable place of setting up, the
necessary additional space requirement for the movement room of the operating and
service personnel must be taken into consideration. Solvents are processed in the
device, adequate room ventilation must be ensured!
To Next Page
Loading...
