Leibinger JET3 up - Figure 55 Solvent Saving Mode

Group 8 Job Editor Page 145
JET3up Release R1.06
Figure 55 Solvent Saving Mode
.
Solvent Saving Mode
off
3 Minutes
Die Solvent Saving
Mode function is not
active
After 3 minutes without a received
PrintGo signal the nozzle will close
automatically.
1 – Dialog box <Basic Settings>
4 – Input field <Time to close nozzle>
2 – Tab <Solvent Saving Mode>
5 – <PG Monitoring> off
→
set to “0”
3 – Spin buttons <Time to close
nozzle>
6 – <PG Monitoring> on → set to “3”
1
2
4
3
6
5