Page 376 Setting-up/Maintenance Group 10
Release R1.06 JET3up
10.1.3 Daily servicing work
The daily servicing work includes the checking of the print head and in particular of
the deflector unit, the charging electrode as well as of the guides for dirt. If
necessary the components must be cleaned as described in the chapter Cleaning.
10.1.4 Weekly servicing work
The weekly servicing work includes the checking of the spindles and of the guides
of the nozzle seal for dirt. If necessary the components must be cleaned as
described in the chapter Cleaning.
This work must only be carried out by trained personnel or by
Leibinger service technicians!
10.1.5 Annual servicing work
The manufacturer recommends a regular servicing interval of 6–12 months.
This work must only
be carried out by trained personnel or by
Leibinger service technicians!
10.1.6 Spare parts and wear and tear parts
It is strongly recommended using only genuine LEIBINGER spare parts and wearing
parts. Only by this a safe and accurate operation is ensured. LEIBINGER offers a
wide range of spare parts and wear and tear parts. Please ask your local LEIBINGER
dealer for details.
Using third party parts may affect the warranty!
A spare part
is an interchangeable part that is kept in an inventory and
used for the repair or replacement of failed units.
Wear and tear parts:
Wear and tear parts underlie damages that naturally and inevitably
occurs as a result of normal wear or aging.
A spare part may also be a wear and tear part!
To Next Page
Loading...
