Leibinger JET3 up - Stop after X Products - Pre-Defined Print Stop

Page 188 Job Editor Group 8
Release R1.06 JET3up
7.5.2.1 Stop after x products - Pre-defined print stop
With the option <Stop after x Products> the amount of prints will be defined after
the LEIBINGER JET3up should release an automatic print stop.
If a print stop has been pre-
defined the value is displayed in the status field
<Production Counter> of the main window.
ATTENTION
Before the re-start of the production, the production counter has to be
necessarily reset to get a correct result.
Proceeding (see figure 85)85:

Press the option <Stop after x Products> (2).
 The dialog box <Stop at x Products> (3) pops up.
 Set the value with the Arrow keys (4). The value of the counter will be
increased or reduced in single steps by pressing the accordant buttons.
or
 Click in the input field (5). The Numeric keypad (6) opens for input.
INFORMATION
You will find further information regarding the working with Numeric
keypads in the chapter 6.4.1 Numeric keypad

Confirm the value set by pressing the
<Set>
button
(7)
or cancel the process
with the <Cancel> button (8).
 The value set is displayed in the <Product Counter> status field (9) of the
main
window. A pre-
defined print stop setting is marked with a red frame for better
for better visualization.
 If the x-value set is equal or lower than the value set for the 1. production
counter the input will be ignored.