Page 34 Accident prevention Group 3
Release R1.06 JET3up
3.4 Measures in the event of accidental release (spillage)
Spilled ink and solvent should be removed immediately. Used
wiping material could pose a potential fire hazard and have to be
disposed in accordance with the regulations.
MEASURES
Switch off sources of ignition and ventilate room. Keep personnel
that is not absolutely necessary away. Do not inhale any vapour.
Observe the protective measures listed.
PROTECTION
MEASURES
DO NOT allow to enter waste water channels or waters.
Should the product enter waste water channels or the drainage
system the local water supply authority must be informed
immediately. In the event of contamination of streams, rivers or
lakes inform the national water authorities. Vapour is heavier than
air and can spread out on the ground. In combination with air it
can form an explosive mixture.
Restrict and suck up spilled substances with a non-combustible
absorbent material (e.g. sand, earth, vermiculite, infusorial earth)
and collect in a suitable container for removal. Preferably clean
areas with spilled substances with a detergent. Avoid solvents.
To Next Page
Loading...
