Leibinger JET3 up - Figure 140 - Print Parameter; Print Parameter

Group 8 Job Editor Page 265
JET3up Release R1.06
8.5.2 Print parameter
The <Print Parameter > tab provides parameters for the the kind of text output,
the PrintGo source and several mo
nitoring functions in combination with sensor
evealuations.
List of available settings:

PrintGo-Delay

Monitoring and control functions
 PrintGo-Distance  PrintGo length
 PrintGo-Repeat  PrintGo tolerance
 PrintGo-Holdoff Distance  Drop Flighttime
 PrintGo Source  PrintGo-Gate
Important
The JET3up printer works with an internal shift register for PrintGo
signals. Up to 8 PrintGo signals are buffered. This allows distances
between the products to be printed on which are shorter than the length
of a single product.
Note:
Because of the size of the buffer the shift register will only work properly
as long as there are not more than 8 products between the PrintGo
sensor and the printhead.
Figure 140 Print parameter tab
1 – PrintGo delay settings
7 – PrintGo length settings
2 – PrintGo distance settings
8 – PrintGo tolerance settings
3 – PrintGo repeat settings
9 – Drop-Flighttime compensation
4 – PrintGo Holdoff distance settings
10 – PrintStop settings
5 – PrintGo Source settings
11 – PrintGo gate settings
6 – Print control settings
1
2
6
7
3
4
5
8
9
10
11