Leibinger JET3 up - Ethernet-Connection; Interface X5 - Printgo

Group 5 Transport/Start up Page 59
JET3up Release R1.06
5.5.1 Ethernet-connection
The Ethernet-connection is implemented with a sturdy M12D coded socket and is
designed for high transfer rates and long cable lengths. It provides the networking of
several devices in multi-head applications. The data exchange happens via the
„LEIBINGER JET3up-interface protocol“.
Plug assignment:
Pin connection:
5.5.2 Interface X5 - PrintGo
The interface X5 provides the connection of an external PrintGo-signal. All common
product detectors (e.g. light barrier, product sensor ect.), 24V NPN-
as well as 24V
PNP-switching can be connected. The PrintGoGate input requires a PNP sensor!
Regarding the software you can select additionally if the positive edge or the negative
edge should be used for the release of the printout.
Note:
To inform the JET3up when a print text should be printed, you require a so-called
Print-Go signal.
Plug assignment:
Pin connection:
Pin No
Designation
Pin No.
Designation
1
Tx +
3
Tx -
2
Rx +
4
Rx -
Pin
Designation
Pin
Designation
1
+24 V
(1)
4
PrintGo
2
/PrintGo
5
PrintGo_Gate
3
GND