Leibinger JET3 up - Figure 152 - Printgo-Gate;Print Start Control; Printgo-Gate;Print Start Control

Group 8 Job Editor Page 275
JET3up Release R1.06
8.5.2.9 PrintGo-Gate - Print start control
This function offers an additional option to control the print start. With this
function enabled the printout starts only as long as the monitored sensor is active
during the PrintGo signal.
The inputs for the sensor signals are located on the connector of interface X5 of
the LEIBINGER JET3up.
Figure 152 PrintGo-Gate /Print start control
Activating options:

High-Level active:
Gate
PG signals
Signals are
not
processed

Low-Level active:
Gate
PG signals