Leibinger JET3 up - Figure 71 I;O-Signal Test; I;O Test - Signal Test

Page 166 Job Editor Group 8
Release R1.06 JET3up
7.4.1 I/O Test - Signal test
With the option <I/O Test> (2) the dialog box „I/O-Signals (3)“ is displayed. The
dialog box shows the states of the inputs and outputs of the device.
Figure 71 I/O-Signal test
1 – Drop-down menu<ServiceFunctions>
5 – Signal counter for PrintGo signals
2 – Option <I/O-Test>
6 – Status indicator <I/O active>
3 – Dialog box <I/O-Signals>
7 – Status indicator <I/O inactive>
4 – Signal counter for channels A and B of
the encoder
8 – Decimal value of the current Job
Select address
9 – <Close> Button
1
2
9
6
3
8
4
7
5