Leibinger JET3 up - Figure 124 Job Editor (Load Job to Print); Load Job to Print

Page 244 Job Editor Group 8
Release R1.06 JET3up
8.3.2 Load job to print
With the option <Load Job to print> the job which is currently opened in the job
editor can be loaded directly for printing.
Figure 124 Job editor (Load job to print)
1 – Drop down menu <Job>
6 – Button <Close>
2 – Option <Load Job to print >
7 – Option <Close Editor>
3 – Message <Print job change>
8 – Message <Reload original job>
4 – <OK> Button
9 – Button <OK>
5 – <Cancel> Button
Proceeding:
 Press the button <Job> (1) and the option <Load job to print> (2).
 A confirmation prompt (3) pops up.
 Confirm the change by pressing on the <OK> button (4)
or cancel the process
with the button <Cancel> (5).
 The job in the job editor is now loaded for printing. Attention! If there already
occurred a <PrintGo> signal for the original job, the JET3up starts immediately
the printing process.
1
2
5
3
4
8
6
7
9