Leibinger JET3 up - Switching on with Password Protetction

Group 8 Job Editor Page 83
JET3up Release R1.06
6.5.3.2 Switching on with password protetction
Proceeding:

Touch the dark Touch-Display (1) for at least 2 seconds.
 The device turns on and the main window (3)
is displayed with the message
<Initialization> (2).
 After the initialization the device starts with the bleeding of the syst
em
automatically.
 During the process the message <Bleeding> (4)
is displayed. The bleeding
takes between 1 –
5 min. The process can be canceled by pressing the button
<Cancel> (5).
Note:
The start of the device happens in the logged-out status (no operator will be
logged on) but the job which has been used at last will be loaded automatically.
 The dialog field <Current login> (6) and a keyboard field (8) pops up.
INFORMATION
You will find further information regarding the operation with
keyboard in the chapter 6.4.2 Keyboard

Enter your password with the keyboard field.
 Press the button <Enter> (9) of the keyboard field to finish the input.
 Now press the button <Login> (10) to finish the login.
 Now the user is logged-in and the active password level is displayed on top right
of the title bar (11).
ATTENTION
The login can be also carried out without a password. In this case
only several
basic functions of the device are available for the
user.
You will find further information in the chapter 7.3.5 Password
settings and user permissions