Group 12 Appendix - Connection Examples for the Interfaces Page 385
JET3up Release R1.06
12.2 Connection examples for the interfaces
The wiring examples which are described in the following are only for support. Other
combinations, actuators, sensors and switching elements are of course possible and
cannot be described completely here.
For the connection please pay attention to the specifications which are described for the
plug assignment!
12.2.1 Interface X 3 - Outputs
The described examples are possible at all 8 outputs.
Inputs:
Is used when a printer-output is connected to an input of a external logic (e.g.
PLC). Due to the high resistance of the low level signal of the output driver, a
20kOhm Pull-down resistor is recommended.
The resistor can be dropped if the following input wiring has already an accordant
low input resistance.
LED's:
LED can be connected by a series resistance. (as in the example for a LED with UF
= 2V and I nominal = 20mA)
Inductive Loads:
For the usage of inductive loads (relay, motors etc.) a parallel-
avoid a turning-off peak.
Lamps or Resistors:
Lamps or other resistor loads can be directly connected to the output, but the sum
of the output loads should not be
higher than 700 mA (in sum of all outputs
together).
To Next Page
