Group 8 Job Editor Page 91
JET3up Release R1.06
7 Data entry/Programming
7.1 General
Data which should be printed by the LEIBINGER JET3up can be entered, called,
changed and saved with several input devices, e.g. TFT-Touch display, mouse etc..
The printer can also be programed and controlled with the (RS232/Ethernet) per
external software (according to the Leibinger interface protocol for the JET3UP).
Further more the LEIBINGER JET3up can also carry out several functions (e.g. job
selection) by the control with digital signals (e.g. out of a SPS) and can be therefore
also controlled locally.
In the following the operation and programming with the TFT-Touch display are
described.
To Next Page
Loading...
