Page 172 Job Editor Group 8
Release R1.06 JET3up
7.4.4 Special functions and tools
Under the tab <Special Functions/Tools> the following functions are available:
Pressureless Calc last PG Drops
Constant Bleed Mix only Ink
Deplete Ink Mix only Solvent
Deplete Solvent Fill up Routine
Calc Delay Time Ignore error messages and warnings
7.4.4.1 Constant bleed
The function constant bleeding is only activated or functional under
the following device conditions:
Ink suction is turned on
Nozzle is closed
Head cover is removed
By pressing the button <Constant Bleed> (1) the constant bleeding is started.
During the process the message „Constant Bleed“ (2)
is displayed. The bleeding can
be canceled any time by pressing on the button <Stop> (3)
. During this process
the visco pump is activated for 3 sec. every minute to ensure a purging of the
pump.
With the button <Add Solv> (4)
you can add only solvent. This function provides
specially filling operations to bleed e.g. th
e solvent tube or to set the viscosity of
the ink faster to a lower value.
By adding solvent the ink can be diluted too strong. Therefore this
function should only be carried out by qualified personnel.
To Next Page
