Leibinger JET3 up - Page 206

Page 204 Job Editor Group 8
Release R1.06 JET3up
Drawing area
On the draw
ing area the current content of the selected ASCII character is
displayed. You can edit the character using the tools and commands from the menu
bar. To change the size of the drawing area and to set the grid you can use the
options from the <View> drop-do
wn menu. The status bar at the bottom side of
the drawing area displays instructions for the current tool or command. There are
x-
y indicators in the lower right corner of the font editor. They show the position of
the point in the drawing area on which was clicked last.
Example:
First you draw a rectangle using the rectangle tool (1 to 3). Then you select the
rectangle with the selection tool (4). The selection tool creates a red frame (5).
At last you use the <Delete> command to delete the selected area (6-7).
Command buttons
1
2
3
4
5
6
7
1
2
3
4
6
5