Group 8 Job Editor Page 217
JET3up Release R1.06
2. Deletion of graphic elements:
(Example: On side of a rectangle and a complete line shall be deleted)
Start with the deletion of the line.
Select the <Selection> tool (2) from the the <Function> drop-
(1).
The selection frame is defined by two corner points (3) and (6) . Place the
corner points in a way that the selection frame covers the line to be deleted.
The <Coordinates> indicator (4) displays the respective positions of the
corner points. The <Status bar for the current tool> (5) provides
information for each step.
Select the <Delete> tool (8) from the <Edit> drop-down menu (7) .
The line covered by the selection frame will be deleted.
In the next step one side of the rectangle will be deleted.
Select the <Selection> tool (2) from the <Function> drop-down menu (1).
Define the first corner point for the selection frame (11)
contour of the rectangle will be interrupted. This point will be marked red.
Define the second corner of the selection frame (12). This point is positioned
just one dot below the first corner point. Actually this results not in a
selection frame but in a selection line.
Select the <Delete> tool (8) from the <Edit> drop-down menu (7).
The part of the rectangle covered by the selection frame will be deleted.
To Next Page
