Page 26 Safety Group 2
Release R1.06 JET3up
WARNING
Always ground yourself and the printer to the same potential before
filling the reservoirs! Simply touch the housing of the printer to
discharge the equipment or you must stand on a grounded surface
wearing ESD shoes during filling!
Burning gases and liquids may cause severe burns. Keep sources of
ignition away from the printer!
Read the safety data sheets and the persona
rules and regulations!
Safe handling
These products may be used only in places that are completely free from open
flames and other ignition sources. Use only spark-free tools. Electrical equipment and
tools used must comply with the ATEX Directive.
Keep product containers tightly closed during operation. Avoid vapor concentrations
that exceed the limit values specified by the employers’ liability insurence
association.
Do not use pressure to empty the product container - the container is not a pressure
vessel.
The product may become statically charged. Use a grounded line to transfer from
one container to another.
An uncluttered, clean working environment and regular, safe disposal of waste
materials minimize the risk of spontaneous ignition and other fire hazards.
If the printer is ever operated in a way that allows it to print into a beaker, the
beaker must be made of conducting material and be securely connected to earth
(ground), as the electrostatic charges on the ink drops used for printing could built
up an eletrostatic charge and may cause a fire hazard.
Employees must wear antistatic footwear and clothing, and the floors must be
conductive.
Avoid skin or eye contact. Do not inhale vapors and spray mists.
WARNING
Before filling the device with the consumables, measures for the
electrostatic discharge have to be made!
Highly flammable! Burning gases and liquids may cause severe
burns. Keep sources of ignition away from the printer!
Always statically
discharge the printer and yourself before filling
the reservoirs! Simply touch the housing of the printer to discharge
the equipment and stand on a grounded surface wearing ESD
shoes during filling!
To Next Page
Loading...
