EasyManuals Logo

Lexmark T65 Series Service Manual

Lexmark T65 Series
665 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #139 background imageLoading...
Page #139 background image
Diagnostic information 2-105
7462
Go Back
Previous
Next
950.xx NVRAM mismatch
failure
Mismatch between system
card EEPROM and operator
panel mirror.
".xx" codes:
00-29: mismatch between
system and mirror
30-60: mismatch between
secure and system
Warning: When replacing any
of the following components:
Scanner interface card
assembly.
System card assembly
Only replace one component at
a time. Replace the required
component and perform a POR
before replacing a second
component listed above. If this
procedure is not followed, the
printer will be rendered
inoperable. Never replace two
or more of the components
listed above without a POR
after installing each one or the
printer will be rendered
inoperable.
Never install and remove
components listed above as a
method of troubleshooting
components. Once a
component has been installed
in a machine, it can not be
used in another machine. It
must be returned to the
manufacturer.
Go to NVRAM mismatch failure
service check.
See “NVRAM mismatch
failure (950.00 through
950.29) service check” on
page 2-154.
952.xx NVRAM failure A recoverable MVRAM Cyclic
Redundancy Check (CRC)
error occurred.
Power the machine off/on to
reset the error condition.
953.xx NVRAM failure The NVRAM chip has failed on
the scanner interface card
assembly.
Replace the scanner interface
card assembly.
Go to “Scanner interface
card assembly removal” on
page 4-144.
954.xx NVRAM failure
NVRAM chip failure with
system card assembly.
Replace the system card
assembly.
Go to “System card
assembly removal on
page 4-47.
955.xx NAND FLASH Failure The Code ROM or NAND flash
failed the Cyclic Redundancy
Check (CRC) check or the
NAND experienced an
uncorrectible multi-bit failure.
Replace the system card
assembly.
Go to “System card
assembly removal on
page 4-47.
956.xx System card
processor failure
The processor has failed on
the system card assembly.
Replace the system card
assembly.
Go to “System card
assembly removal on
page 4-47.
Error
code or
message
Error contents Description/Action Possible repair actions

Table of Contents

Other manuals for Lexmark T65 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lexmark T65 Series and is the answer not in the manual?

Lexmark T65 Series Specifications

General IconGeneral
BrandLexmark
ModelT65 Series
CategoryPrinter
LanguageEnglish

Related product manuals