Preventive maintenance 6-1
7462
6. Preventive maintenance
This chapter describes procedures for printer preventive maintenance. Follow these recommendations to help
prevent problems and maintain optimum performance.
Safety inspection guide
The purpose of this inspection guide is to aid you in identifying unsafe conditions.
If any unsafe conditions exist, find out how serious the hazard could be and if you can continue before you
correct the hazard.
Check the following items:
• Damaged, missing, or altered parts, especially in the area of the On/Off switch and the power supply
• Damaged, missing, or altered covers, especially in the area of the top cover and the power supply cover
• Possible safety exposure from any non-Lexmark attachments
Lubrication specifications
Lubricate only when parts are replaced or as needed, not on a scheduled basis. Use of lubricants other than
those specified can cause premature failure. Some unauthorized lubricants may chemically attack
polycarbonate parts. Use IBM no. 10 oil, P/N 1280443 (Approved equivalents: Mobil DTE27, Shell Tellus 100,
Fuchs Renolin MR30), IBM no. 23 grease (Approved equivalent Shell Darina 1), and grease, P/N 99A0394 to
lubricate appropriate areas. Use Nyogel type 774 to lubricate the Fuser Drive Assembly and Nyogel 744 to
lubricate the ITU and Cartridge Drive assemblies.
Individual maintenance part expected life
Description
Part
number
Expected
part life
Charge roll assembly with tool 40X5852 300K
Transfer roll assembly with tool 40X1886 300K
Pick roll assembly (2) 40X4308 300K
Printer maintenance kit (100 V type 1 fuser) 40X4723 300K
Printer maintenance kit (110 V type 1 fuser) 40X4724 300K
Printer maintenance kit (220 V type 1 fuser) 40X4765 300K
Printer maintenance kit (100 V type 2 fuser) 40X4766 150K
Printer maintenance kit (110 V type 2 fuser) 40X4767 150K
Printer maintenance kit (220 V type 2 fuser) 40X4768 150K
ADF feed / pick roll assembly 40X4540 120K
ADF separator roll and guide 40X4605 120K
To Next Page
Loading...
Need help?
General
