Lexmark T65 Series Service Manual

Repair information 4-165
7462
Go Back
Previous
Next
3. Remove the three screws (A) securing the HCIT controller card assembly.
4. Remove the HCIT controller card assembly and the shield.
High capacity input tray (HCIT) media size actuator assembly removal
Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1. Remove the HCIT controller card assembly. See “High capacity input tray (HCIT) controller card
assembly removal” on page 4-164.
2. Disconnect the two springs (A) from the frame.
3. Slide the cam size sensing plate (B) through the access hole in the rear side frame.
A
A
B

Lexmark T65 Series Specifications

General

Brand	Lexmark
Model	T65 Series
Category	Printer
Language	English