Diagnostic information 2-11
7462
Error code table
Error
code or
message
Error contents Description/Action Possible repair actions
200.00 Sensor (input) area
jam
The media is jammed in the
sensor (input) area.
1. Fan the media and check for
obstructions.
2. Go to sensor (input) service
check.
See “Sensor (input) service
check” on page 2-108.
200.01 Sensor (input)
lingering jam
Source = MPF, duplex
or envelope feeder
The media reached the sensor
(input) but did not clear it within
the specified time.
1. Fan the media and check for
obstructions.
2. Go to sensor (input)
lingering jam service check.
See “Sensor (input) lingering
jam service check.” on
page 2-130.
200.02 Sensor (input)
lingering jam
The media reached the sensor
(input) but did not clear it within
the specified time.
1. Fan the media and ensure it
is properly installed.
2. Go to sensor (input)
lingering jam service check.
See “Sensor (input) lingering
jam service check.” on
page 2-130.
200.04 Sensor (input) early
jam
The media reached the sensor
(input) sooner than the
specified time.
Wrong config ID causes engine
to assume 500 paper path on
250 model.
1. Fan the media and ensure it
is properly installed.
2. Go to sensor (input) early
jam service check.
See “Sensor (input) early jam
service check” on
page 2-131.
200.06 Sensor (input) early
jam
The sensor (input) rebounded
once the trailing edge of the
media passed.
Go to sensor (input) service
check.
See “Sensor (input) service
check” on page 2-108.
200.07 Sensor (input) late
jam
Source = input option
tray
The media is late reaching the
sensor (input) within the
specified time.
Go to sensor (input) late jam
service check.
See “Sensor (input) late jam
service check.” on
page 2-128.
200.08 Sensor (input) early
jam
The media reaches the sensor
(input) sooner than the
specified time.
1. Fan the media and ensure it
is properly installed.
2. Go to sensor (input) early
jam service check.
See “Sensor (input) early jam
service check” on
page 2-131.
To Next Page
Loading...
Need help?
General
