Repair information 4-5
7462
Removal procedures
Before starting service work
Note: Some removal procedures require removing cable ties. You must replace cable ties during reassembly
to avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
Note: A wide variety of screws are used; make note of their positions during service.
Charge roll assembly removal
WARNING: When removing the charge roll assembly, avoid touching the charge roll surface.
1. Open the MPF door assembly.
2. Open the operator panel door assembly or the print cartridge door assembly.
3. Detach the left side of the charge roll assembly from the machine.
CAUTION:
Remove the power cord from the electrical outlet before you connect or disconnect any cable
or electronic board or assembly.
CAUTION:
While performing service around the fuser assembly, ensure the fuser area has cooled down.
To Next Page
Loading...
Need help?
General
