Diagnostic aids 3-33
7462
Factory Defaults
This setting enables a user to restore all the printer settings to the original factory settings. Selections are
Restore Base, Restore STD NET, or Restore LES. Restore LES enables you to remove all Lexmark
Embedded Solutions applications (LES).
Network does not appear unless you have a network printer. The following settings are not changed:
• Display language
• Settings in the NETWORK/PORTS MENU group.
To reset factory defaults:
1. Touch to select Factory Defaults from the Configuration Menu.
2. Touch to select either Restore Base, Restore STD NET, or Restore LES.
Note: There is no confirmation, and selecting one of these settings immediately takes effect. The MFP
restarts and returns to Ready state.
Restoring Factory Defaults and then Resetting the Device are displayed.
Energy Conserve
This menu controls what values appear on the Power Saver menu. If Off is selected in Energy Conserve
menu, then Disabled appears in the Power Saver menu, and Power Saver can be turned off. If On is set in
Energy Conserve, the Power Saver feature cannot be disabled.
1. Touch to select Energy Conserve from the Configuration Menu.
2. The panel displays the setting's name in the header and [setting's current value] below the header
row. Touch or to change the setting. The selections are On and Off. The default is On.
3. Touch Submit to save your change.
Touch Back to exit without changing the value.
Factory Defaults
Restore Base
Restore LES
Restore STD Net
Back
To Next Page
Loading...
Need help?
General
