3-30 Service Manual
7462
USB Scan to Local
To change the USB Scan to Local setting:
1. Touch to select USB Scan to Local from the Configuration Menu.
2. The panel displays the setting's name in the header and [setting's current value] below the header
row. Touch or to change the setting. The selections are On and Off. The default is Enable.
3. Touch Submit to save your change.
Touch Back to exit without changing the value.
Print Quality Pages
The print quality test pages can be printed from either the Diagnostics Menu or Configuration Menu (CONFIG
MENU). When printed from the Diagnostics Menu, additional information is included, and the print cartridge
lockout is bypassed. See “USB Scan to Local” on page 3-30. Additional configuration information may be
included on the print quality pages which is not included on the print menu page.
To print the Print Quality Test Pages, touch to select Print Quality Pages from Configuration Menu. The
message Printing Quality Test Pages is displayed.
The following is printed on the first page:
• Device Information to include page count, installed memory, processor speed, serial number engine ID,
system card ID, and printer revision levels
• Cartridge Information
• Printer Margin Settings
• Scanner Margin Settings
• Minimum Stroke Width
The print quality pages consist of four pages. Page one contains a mixture of graphics and text. Page two is
gray with two one-inch black squares located on the bottom right. Page three is solid black page and page four
is blank. If duplex is turned on, the pages are duplexed. The Print Quality Test pages are printed in English and
must always be printed on letter, legal, or A4 paper.
To Next Page
Loading...
Need help?
General
