3-10 Service Manual
7462
Touch Exit Diag Menu to exit the Diagnostics Menu, and Resetting the Printer displays. The printer
performs a POR, and the printer returns to ready mode.
PRINTER SETUP
Defaults See “Defaults” on page 3-22
Printed Page Count See “Printed Page Count” on page 3-22
Perm Page Count See “Permanent Page Count” on page 3-22
Serial Number See “Serial Number” on page 3-22
Envelope Enhance See “Engine Settings 1 through 16” on page 3-22
Engine Settings 1 through 16 See “Engine Settings 1 through 16” on page 3-22
Model Name See “Model Name” on page 3-22
Configuration ID See “Configuration ID” on page 3-23
Edge To Edge See “Edge to Edge” on page 3-23
Enable Edge to Edge Copy See “Enable Edge to Edge Copy” on page 3-23
EP SETUP
EP Defaults See “EP Defaults” on page 3-24
Fuser Temp See “Fuser Temperature (Fuser Temp)” on page 3-24
Fuser Page Count See “Fuser Page Count” on page 3-24
Warm Up Time See “Warm Up Time” on page 3-24
Transfer See “Transfer” on page 3-25
Print Contrast See “Print Contrast” on page 3-25
Charge Roll See “Charge Roll” on page 3-25
Gap Adjust See “Gap Adjust” on page 3-25
Auto Dark Adjust See “Auto Dark Adjust” on page 3-25
REPORTS
Menu Settings Page See “Menu Settings Page” on page 3-25
EVENT LOG
Display Log See “Display Log” on page 3-25
Print Log See “Print Log” on page 3-26
Clear Log See “Clear Log” on page 3-26
SCANNER TESTS
Back Side Scan Uniformity See “Back Side Scan Uniformity” on page 3-27
ASIC Test See “Back Side Scan Uniformity” on page 3-27
Feed test See “Feed Test” on page 3-27
Sensor Tests See “Sensor Tests” on page 3-27
Diagnostics Menu tests (Continued)
To Next Page
Loading...
Need help?
General
