2-26 Service Manual
7462
202.87 Sensor (fuser output)
lingering jam.
Destination is output
option.
Type 2 fuser
Fuser page count has
exceeded life.
Media reached the sensor
(fuser output) but did not clear
it in the specified time.
and
Media did reach the sensor
(narrow media)
Go to sensor (fuser output)
lingering jam service check.
See “Sensor (fuser output)
lingering jam service check.”
on page 2-134.
202.88 Sensor (fuser output)
static jam
and
Sensor (narrow
media) static jam
Type 2 fuser
Fuser page count has
exceeded life.
Media remains on the sensor
(fuser output) and the sensor
(narrow media) during the
warm up sequence.
1. Go to sensor (fuser output)
static jam service check.
See “Sensor (fuser
output) static jam service
check” on page 2-136.
2. Go to sensor (narrow
media) static jam service
check. See “Sensor
(narrow media) static jam
service check” on
page 2-137.
202.99 Fuser ID chip failure The system does not recognize
the ID chip on the fuser unit.
Replace the fuser unit
assembly.
Go to “Fuser unit assembly
removal” on page 4-16.
203.00 Paper jam around
redrive area.
Page may be jammed in
redrive area.
1. Remove all media present
in media path.
2. Check media for proper
installation.
3. Check for obstructions in
media path.
4. Go to sensor (fuser output)
service check. See
“Sensor (fuser output)
service check” on
page 2-108.
5. Go to sensor (narrow
media) service check. See
“Sensor (narrow media)
service check” on
page 2-109.
203.01 Internal duplex drive
motor control failure.
Internal duplex
The internal duplex drive motor
motor does not reach the
proper operating speed at the
specified time.
1. Remove all media present
in media path.
2. Check all connections on
the duplex media entrance
drive motor assembly.
3. Check all connections on
the system card assembly.
4. Replace the duplex media
entrance drive motor
assembly if problem
remains. Go to “Duplex
drive motor assembly
removal” on page 4-9.
Error
code or
message
Error contents Description/Action Possible repair actions