Rev.1
Page 1-
29
3. Confirm the selection with the ↵ key.
When the PRION program is selected, you will go to a screen for selecting the sterilization time.
TIME: XX min
+/-to set
↵ to enter
to exit
A value can be set, starting from 18 minutes.
As a function of the choices made, you will go to one of two alternative menus that allow selecting the type of drying to associate to the selected
program .
a) Programs with short drying (HOLLOW, SOLID, EMERGENCY):
→ STANDARD DRYING +
FAST DRYING ↑
EXIT ↓
-
It is possible to select STANDARD mode (the default
setting) or FAST (reduced drying, recommended for light loads). Move using the + and -
keys and confirm with the ↵ key.
e The EMERGENCY program provides only FAST drying
b) Programs with long drying (POROUS, WRAPPED, PRION):
→ STANDARD DRYING +
INTELL. DRYING ↑
EXTRA DRYING ↓
EXIT -
To Next Page
