Rev.1
Page 1-
32
Select FRACTION. to perform a fractionated vacuum (indispensable for sterilizing hollow bodies and porous materials), or SINGLE for a
single preliminary vacuum phase (solid instruments). Move using the + and - keys and confirm with the ↵ key.
4. At this point, you come to another menu where you set the drying mode:
→ SHORT DRYING +
LONG DRYING ↑
EXIT ↓
-
Select LONG drying suitable for porous and/or wrapped loads, or SHORT if you need to sterilize solid, loose materials (and even hollow so
long as not wrapped). Move with the + and - , confirm with the ↵ key.
5. Depending on the selection (SHORT or LONG) one of two different menus will open (these menus are the same for the standard cycles), i.e..
In SHORT mode the following is displayed:
→ STANDARD DRYING +
FAST DRYING ↑
EXIT ↓
-
In LONG mode the following is displayed :
→ STANDARD DRYING +
INTELL. DRYING ↑
EXTRA DRYING ↓
EXIT -
For the choice criteria, refer to the instruction.
Whenever the CUSTOM program is already present in another position, the selection is not accepted. The following warning appears on the display, along
with a beep:
To Next Page
Loading...
