BSH2
High-speed
Sequential
SH2
The camera takes photos at up to about 50 fps while the
shutter button is held all the way down. If [C-AF], [C-AFJ],
[C-AF+TR], or [C-AF+TRJ] is selected for [KAF Mode]
(P.100), the camera will focus before each shot.
When [Metering during g] (P.164) is set to [Yes], the camera
will meter the brightness and determines the exposure before
each shot.
ProCap
ProCap SH1
ProCap SH2
Pro Capture
Capture starts when the shutter button is pressed halfway. The
camera starts recording pictures, including those captured while
the button was pressed halfway, when the button is pressed
all the way down (P.200). Focus and exposure during each
ProCap mode are the same as [B] (sSequential), [BSH1]
(sHigh-speed Sequential SH1) and [BSH2] (sHigh-speed
Sequential SH2).
Y12s / r12s
q12s
Self-timer 12
sec
The shutter is released 12 seconds after the shutter button is
pressed all the way down. The self-timer lamp will light for about
10 seconds and then start to flash about 2 seconds before the
shutter is released. The camera focuses when the shutter button
is pressed halfway.
Y2s / r2s
q2s
Self-timer 2
sec
When the shutter button is pressed all the way down, the self-
timer lamp will start to flash and a photo will be taken after
about 2 seconds. The camera focuses when the shutter button is
pressed halfway.
YC / rC
qC
Custom Self-
timer
Adjust self-timer settings, including the self-timer delay and the
number of shots taken when the timer expires (P.195).
You can choose the frame advance rate and the maximum number of shots in each series (P.193).
Items marked with t allow you to take pictures with the small amount of blur caused by operation
of the shutter reduced. Use this option when even slight camera motion can cause blur, for example
during macro or telephoto photography. This is configured when [Anti-Shock H] is set to [On] in
[Anti-Shock H Settings] (P.197).
Items marked with s use the electronic shutter. Use these with shutter speeds faster than 1/8000
seconds, or in settings where the sound of the shutter would be unwelcome.
BSH2 and ProCap SH2 can only be used with specific lenses. Visit our website for details.
To cancel the activated self-timer, press G.
In g, F, B and ProCap modes, the camera displays the view through the lens during
shooting. In BSH1, BSH2, ProCap SH1, and ProCap SH2 modes, it displays the shot
immediately preceding the current frame.
191
Performing the sequential/self-timer shooting
B
B
B
B
B
B
To Next Page
Loading...
Need help?
General
