Connecting to Computers via USB
Installing Software
Install the following software to access the camera while it is connected directly to the computer via
USB.
OM Capture
Use “OM Capture” to automatically download and view pictures as they are taken or control the
camera remotely. To learn more or to download the software, visit our website. When downloading the
software, be prepared to provide the camera serial number.
Follow the on-screen instructions to install the software. System requirements and installation
instructions are available at our website.
OM Workspace
This computer application is used to download, view, and manage photos and movies recorded with
the camera. When editing RAW data in the OM Workspace, high-speed processing using the camera
engine has been enabled. It can also be used to update the camera firmware. The software can be
downloaded from our website. When downloading the software, be prepared to provide the camera
serial number.
Follow the on-screen instructions to install the software. System requirements and installation
instructions are available at our website.
461
Installing Software
To Next Page
Loading...
