The camera displays the number of pictures that can be stored in
the remaining buffer in the following instances:
When the shutter button is pressed halfway, when the shutter
button is pressed fully, when writing to SD card
[
99
][
99
]
1
10231023
P
1
/
250
P
1
/
F
250 5.65.6
1
1
[
1
:
02
:
03
][
1
:
02
:
03
]
FF
60p60p L
-
8L
-
8
S
-
AFS
-
AF
33
200200
L
1
4K
ISO
Auto
ISO
Auto
F
00
+
-
0.00.0
100
%
100
%
When using BSH2 or ProCap SH2 with [C-AF], [C-AFJ], [C-AF+TR] or [C-AF+TRJ]
selected for AF Mode (P.100) and an aperture value larger than F8, the focus accuracy will decrease.
NF will be displayed on the screen.
In BSH1 and ProCap SH1 modes, the lower limit of the shutter speed is 1/15 s.
In BSH2 and ProCap SH2 modes, the lower limit of the shutter speed is 1/640 s when [Max
fps] under [Sequential Shooting Settings] is set to [50fps] and 1/160 s when it is set to [25fps],
[16.7fps], or [12.5fps].
Shooting speed will be lower when [KISO] is 16000 or higher.
When [KISO] is set to 16000 or higher in B mode, the flash sync speed will be 1/50 s and the
shooting speed will be limited to a maximum of 10 fps.
If you stand in front of the camera to press the shutter button when using the self-timer, the picture
may be out of focus.
The speed of sequential shooting varies depending on the lens you are using and the focus of the
zoom lens.
During sequential shooting, if the battery level icon blinks due to low battery, the camera stops
shooting. The camera may not save all of the pictures depending on how much battery power
remains.
Photographs taken in silent and pro-capture modes may be distorted if the subject or camera
moves quickly during shooting.
To use the flash in silent shooting modes, select [Allow] for [Flash Mode] in [Silent I Settings]
(P.198).
Shooting speed may be lower when shooting in a dark place. You may be able to increase shooting
speed by setting [KNight Vision] to [Off]. g“Making the display easier to see in dark places
(KNight Vision)” (P.363)
Number of pictures that can be taken
When it becomes [00] (red), the camera will be unable to record the next picture. When the images in
the buffer are written to the card, the number will increase and the will be able to record pictures.
It is not displayed when there is no card in the camera.
It may not be displayed depending on the functions that are in use.
The number is approximate and not exact. It may change depending on the shooting conditions.
192
Performing the sequential/self-timer shooting
C
C
C
C
C
C
C
C
C
C
C
C
C
B
To Next Page
Loading...
Need help?
General
