OM SYSTEM OM-1 Mark II User Manual

Other external flash units
Third-party flash units can be mounted on the hot shoe or connected via a sync cable. Be sure to
replace the cap on the external flash connector when it is not in use.
Note the following when using a third-party flash unit mounted on the camera hot shoe:
Using obsolete flash units that apply currents of more than about 250 V to the X-contact will
damage the camera.
Connecting flash units with signal contacts that do not conform to our specifications may damage
the camera.
Select mode M, choose a shutter speed no faster than the flash sync speed, and set [KISO] to a
setting other than [Auto].
Flash control can only be performed by manually setting the flash to the ISO sensitivity and
aperture values selected with the camera. Flash brightness can be adjusted by adjusting either
ISO sensitivity or aperture.
Use a flash with an angle of illumination suited to the lens. Angle of illumination is usually expressed
using 35-mm format equivalent focal lengths.
485
Optional Accessories

OM SYSTEM OM-1 Mark II Specifications

General

Camera Type	Mirrorless
Sensor Resolution	20.4MP
Image Processor	TruePic X
Connectivity	Wi-Fi, Bluetooth, USB-C, HDMI
Body Construction	Magnesium Alloy
Dimensions	134.8 x 91.6 x 72.7 mm
Sensor Size	Four Thirds
ISO Range	ISO 200-102400 (expandable to ISO 80-102400)
Image Stabilization	5-axis in-body
Autofocus System	1053-Point Hybrid Autofocus
Viewfinder Type	Electronic (EVF)
Viewfinder Resolution	5.76 million dots
Viewfinder Magnification	1.65x (35mm equivalent)
Rear Screen	3.0" vari-angle touchscreen
Rear Screen Resolution	1.62 million dots
Video Recording	4K UHD at 60p/50p/30p/25p/24p
Video Format	MOV
Audio Recording	Stereo, external mic input
Storage Media	Dual SD Card Slots (UHS-II)
Battery	BLX-1 Lithium-Ion Battery
Weight	599 g (with battery and memory card)
Battery Life	Approx. 520 shots (CIPA standard)
Shutter Speed	1/8000 to 60 sec
Weather Sealing	Yes (IP53 rated)