OM SYSTEM OM-1 Mark II - Functions that Cannot be Selected from Menus; Functions that Cannot be Set from the Super Control Panel; The Subject Appears Distorted; Lines Appear in Photographs

Functions that cannot be selected from menus
When you open the menu, items that cannot be set are displayed in gray. When you press the
OK button while a gray item is highlighted, the reason it is not available is displayed. Refer to the
on-screen instructions and check the settings. g“Items shown in gray” (P.99)
Functions that cannot be set from the super
control panel
Some functions may be unavailable depending on the current shooting settings. Check if the same
function is displayed in gray in the menus.
The subject appears distorted
The following functions use an electronic shutter:
Movie Recording (P.78) / Silent Mode (P.198) / Pro Capture Shooting (P.200) / High Res Shot
(P.239) / Focus Bracketing (P.278) / Focus Stacking (P.250) / Live ND Shooting (P.243) / Live GND
Shooting (P.246) / HDR (P.253)
This may cause distortion if the subject is moving rapidly or the camera is moved abruptly. Avoid
moving the camera abruptly during shooting, or use standard sequential shooting.
Lines appear in photographs
The following functions use an electronic shutter, which may result in lines due to flicker and other
phenomena associated with fluorescent and LED lighting:
Movie Recording (P.78) / Silent Mode (P.198) / Pro Capture Shooting (P.200) / High Res Shot
(P.239) / Focus Bracketing (P.278) / Focus Stacking (P.250) / Live ND Shooting (P.243) / Live GND
Shooting (P.246) / HDR (P.253)
Flicker can be reduced by choosing slower shutter speeds. You can also reduce flicker using flicker
scan. g[KFlicker Scan] (P.157), [nFlicker Scan] (P.157)
498
Shooting tips and information
-
-