OM SYSTEM OM-1 Mark II - Connecting the Camera for High-Speed RAW Processing ( Raw;Control)

Highlight [0RAW/Control] using the FG buttons and
press the OK button.
USB
MTP
Webcam
0
RAW/Control
USB PD
Exit
OK
Storage
Connecting the Camera for High-Speed RAW
Processing (0RAW/Control)
When you edit RAW data with the camera and computer connected, processing will be faster than
when done with the computer only.
After confirming that the camera is off, connect it to the computer using the USB cable.
Turn the camera on.
The camera will display a message prompting you to identify the device to which the USB
cable is connected.
If the message is not displayed, select [Select] for [USB Mode] (P.405).
If the batteries are very low, the camera will not display a message when connecting to a
computer. Be sure the batteries are charged.
Launch the copy of OM Workspace installed on the computer.
Choose the picture to be processed.
Only the pictures that were taken using the following cameras.
OM-1 Mark II/OM-1 (as of January 2024)
You can not choose pictures on the SD card in the connected camera.
Process RAW images.
Adjustments can be made to the shooting settings available on the camera and RAW
pictures processed accordingly.
The processed copies will be saved in JPEG format.
USB RAW data editing is not available when two or more cameras are connected.
See online help for more information on using the software.
464
Connecting the Camera for High-Speed RAW
Processing (0RAW/Control)
1.
2.
3.
4.
5.
6.