Press the INFO button while configuring [KImage
Stabilizer] or [nImage Stabilizer]. Input the focal length
using FGHI and then press the OK button.
K
Image Stabilizer
MENU
OK
0 9 . 0
mm
00
Focal Length
M-IS1 (All Direction Shake I.S.)
Electronic image stabilization combined with VCM-controlled
image sensor movement.
M-IS2 (All Direction Shake I.S.)
VCM-controlled image sensor movement only.
Electronic image stabilization is not performed.
Setting the detailed option of image stabilizer
When using lenses other than Micro Four Thirds or Four Thirds system lenses, input the focal length of
the lens.
Focal Length
Set the lens focal length. Input the number that is printed on the lens.
[0.1] – [1000.0] mm
Image stabilization may be unable to compensate for excessive camera motion or very slow
shutter speeds. Use a tripod in these cases.
You may notice noise or vibration while image stabilization is in effect.
The setting selected with the lens image stabilization switch, if any, takes priority over that
selected with the camera.
This can be changed. g “Stabilization for IS Lenses (Lens I.S. Priority)” (P.210)
[S-IS Auto] functions as [S-IS1] when [On] is selected for [Lens I.S. Priority] (P.210).
When you select [S-IS Auto] or [S-IS1] with B SH2/ProCap SH2 selected as the drive
mode (P.190), the image stabilization will be suitable for camera moves in the depth
direction, compared to when used with other sequential shooting modes.
You can choose whether image stabilization will be performed while the shutter button is
pressed halfway. g “Half-press image stabilization (6Image Stabilizer)” (P.207)
205
Reducing camera shake (KImage Stabilizer /
nImage Stabilizer)
1.
C
C
C
C
C
B
To Next Page
Loading...
