Release the shutter.
The first shot will be visible superimposed on the view through the lens as you compose the
next shot.
The R icon turns green.
Normally, a multiple exposure will be created after the second shot is taken.
Pressing the D button allows you to retake the first shot.
Press the MENU button or press the q button to end multiple exposure photography.
The R icon clears from the display when multiple exposure photography ends.
When [Overlay] is set
When [On] is selected for [Overlay], a list of pictures is displayed.
Highlight an image using the FGHI buttons and press the OK button.
Only RAW images can be selected.
Press the MENU button to exit the menus.
The R icon will be displayed.
The selected picture is overlaid on the screen.
Release the shutter.
You can take additional pictures that will be overlaid on the previously-chosen photograph.
The camera will not enter sleep mode during multiple exposure photography.
Pictures taken with other cameras cannot be used for multiple exposures.
RAW pictures taken using High Res Shot cannot be used for multiple exposures.
The RAW pictures listed in the image-selection display when [On] is selected for [Overlay] are
those processed using the settings in effect at the time the photograph was taken.
Exit multiple exposure mode before adjusting shooting settings. Some settings cannot be adjusted
while multiple exposure mode is in effect.
Performing any of the following operations after the first shot is taken ends multiple exposure
photography:
turning the camera off, pressing the q or MENU button, choosing a different shooting mode,
or connecting cables of any type. Multiple exposure is also canceled when the battery is
exhausted.
257
Recording multiple exposures in a single image
(Multiple Exposure)
2.
1.
2.
3.
C
C
C
C
C
C
-
To Next Page
Loading...
