OM SYSTEM OM-1 Mark II - Page 66

You can choose the functions performed by the front and rear dials. g“Assigning Roles to the
Front and Rear Dials (KDial Function / nDial Function)” (P.347)
You can use the Fn lever to reverse the roles of the front and rear dials. The Fn lever can also be
assigned other roles. g“Customizing the Fn Lever (Fn Lever Settings)” (P.352)
You can choose whether the display reflects the effects of exposure compensation or maintains
a constant brightness for ease of viewing. g“Changing the look of the display (KLV Mode)”
(P.362)
Depending on the shutter speed selected, you may notice banding in the display caused by flicker
from fluorescent or LED light sources. The camera can be configured to reduce the effects of flicker
during live view or when pictures are taken. g“Reducing Flicker in Photographs (Anti-Flicker
Shooting)” (P.203), “Reducing Flicker Under LED Lighting (KFlicker Scan / nFlicker Scan)” (P.157)
Subject Too Dark or Too Bright
If the camera is unable to achieve optimal exposure with [Auto] selected for [KISO], the ISO
sensitivity display will flash as shown.
Display Problem/solution
ISO
Auto
L80
Overexposure.
Choose a higher aperture value or faster shutter speed.
ISO
Auto
25600
Underexposure.
Choose a lower aperture value or slower shutter speed.
If the warning does not clear from the display, choose a higher value for
ISO sensitivity. g“Changing ISO sensitivity (ISO)” (P.166), “Setting the range
of ISO sensitivity values selected in [Auto] mode (KISO-A Upper/Default /
bISO-A Upper/Default)” (P.169)
66
Choosing aperture and shutter speed (M: Manual
Exposure)
B
B
B
B