Administrator Settings
233
7
❖ TEL Line Type
Specifies the line type of the telephone line.
To configure this setting, contact your telephone company and select the set-
ting based on your telephone line. Selecting a wrong setting may cause fail-
ures in fax transmissions.
Default: [Tone]
•Tone
• Pulse 10PPS
• Pulse 20PPS
❖ PBX Selection
Sets the machine to connect to the public switched telephone network (PSTN)
or a private branch exchange (PBX).
Default: [PSTN]
•PSTN
•PBX
❖ PBX Access Digit
Specifies the dial number to access the outside line when the machine is con-
nected to a PBX.
Make sure that this setting matches the setting of your PBX. Otherwise, you
may not be able to send faxes to outside destinations.
Default: 9
• 000 to 999, in increments of 1
❖ Default Mode
Specifies the mode that is activated when the power is turned on, or if the
time specified for [Auto Clear] elapses without activity while the initial screen
of the current mode is displayed.
Default: [Copy]
•Copy
•Fax
❖ Auto Clear
Sets the machine to return to the initial screen of the current mode if the ma-
chine receives no input for a specified period of time during configuration.
Also, if the specified period elapses while the initial screen of the current
mode is displayed, the machine returns to the mode specified in [Default
Mode].
Default: [On] (30 seconds)
• On (30 sec, 1 min, 2 min, 3 min, 5 min, 10 min)
•Off
To Next Page
Loading...
Need help?
General
