EasyManua.ls Logo

Ricoh SAVIN D0AP - E-Mail Parameters

Ricoh SAVIN D0AP
1067 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Dedicated Transmission Parameters
D0C5/D0C6/D0C4/D0AP FAX UNIT 114 SM
used
Bit 7: 1, Bit 6: 1 =
Disabled
• If the setting is "Disabled", the bit switch setting is used.
Switch 04 - Not used (do not change the settings)
Switch 05 - Not used (do not change the settings)
Switch 06 - Not used (do not change the settings)
Switch 07 - Not used (do not change the settings)
Switch 08 - Not used (do not change the settings)
Switch 09 - Not used (do not change the settings)
E-mail Parameters
The initial settings of the following e-mail parameters are all "0" (all parameters disabled).
Switch 00
No FUNCTION COMMENTS
0 MH Compression mode for e-mail
attachments
0: Off
1: On
Switches MH compression on and off for files
attached to e-mails for sending.
1 MR Compression mode for e-mail
attachments
0: Off
1: On
Switches MR compression on and off for files
attached to e-mails for sending.
2 MMR Compression mode for e-mail
attachments
0: Off
1: On
Switches MMR compression on and off for files
attached to e-mails for sending.
3-6 Not used Do not change these settings.
7 Designates the bits to reference for
compression method of e-mail
attachments
0: Registered (Bit 0 to 6)
1: No registration.
The "0" selection (default) references the settings for
Bits 00, 01, 02 above. The "1" selection ignores the
selections of Bits 00, 01, 02.

Table of Contents