Fax Unit Options
SM 9 D0C5/D0C6/D0C4/D0AP FAX UNIT
(D0C5/D0C6
/D0C4/D0AP)
6. Press [OK] after “Connection Test” has been successfully done.
7. Press [Exit] to terminate the System Settings.
Configuring the Remote Reception Settings
Do the following procedure to enable the Client-side Machine(s) to receive faxes via the
Remote Machine. You can forward or route received documents per line or special sender.
• By performing procedures described above (Installing the application in the Remote
Machine and Client-side Machine, Registering the Client-side Machine(s), Registering
the Remote Machine), the Client-side Machines can send faxes via the Remote
Machine. The procedures shown below are necessary to enable the Client-side
Machines to receive faxes.
On the Remote Machine:
1) If you use "Remote Reception Setting per Line"
1. Press [Facsimile Features].
2. Press [Remote Reception Setting per Line] in [Reception Settings].
3. Enter an IP address or a hostname of the client-side machine to connect.
4. Press [Set], and [Exit] to exit from the setting.
2) If you use "Remote Reception per Sender"
1. Press [Facsimile Features].
2. Press [Program Special Sender] in [Reception Settings].
To Next Page
Loading...
