Ricoh SAVIN D0AP - Page 11

SM v D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
3.3 PAPER TRANSFER QUALITY STANDARDS ............................................................ 3-4
4. REPLACEMENT AND ADJUSTMENT ..........................................4-1
4.1 NOTES ON THE MAIN POWER SWITCH ................................................................. 4-1
4.1.1 CHARACTERISTICS OF THE PUSH SWITCH (DC SWITCH) ........................ 4-1
4.1.2 SHUTDOWN METHOD ................................................................................... 4-2
4.1.3 FORCED SHUTDOWN ................................................................................... 4-3
4.2 GENERAL CAUTIONS .............................................................................................. 4-4
4.3 SPECIAL TOOLS AND LUBRICANTS ....................................................................... 4-5
4.3.1 LOCATIONS TO APPLY GREASE ................................................................... 4-6
Drum Drive .......................................................................................................... 4-6
Paper Feed Drive ................................................................................................ 4-8
Feed/Fusing Drive ............................................................................................. 4-10
Fusing Pressure/Release Motor Drive ............................................................... 4-12
Paper Feed Drive (Optional Bank) ..................................................................... 4-16
4.3.2 LOCATIONS TO APPLY QUICK DRYING GREASE ...................................... 4-17
Drum Drive ........................................................................................................ 4-17
Paper Feed Drive .............................................................................................. 4-17
Paper Feed Drive (Optional Bank) ..................................................................... 4-18
4.3.3 LOCATIONS TO APPLY GREASE IN THE FUSING UNIT ............................. 4-19
Inside Fusing Unit .............................................................................................. 4-19
4.3.4 LOCATIONS TO APPLY GREASE IN THE SCANNER UNIT ......................... 4-21
Inside Scanner Unit ........................................................................................... 4-21
4.4 SMC REPORT STORAGE ....................................................................................... 4-23
4.5 EXTERIOR COVERS (PRINTER MODEL) .............................................................. 4-26
4.5.1 RIGHT COVER (PRINTER) ........................................................................... 4-26
4.5.2 LEFT COVER (PRINTER) ............................................................................. 4-28
4.5.3 FRONT COVER (PRINTER) .......................................................................... 4-29
4.5.4 OPERATION PANEL (PRINTER) ................................................................... 4-31
4.5.5 UPPER COVER (PRINTER) .......................................................................... 4-32
4.5.6 REAR LOWER COVER (PRINTER) .............................................................. 4-32
4.5.7 REAR COVER (PRINTER) ............................................................................ 4-33
4.6 EXTERIOR COVERS (MF MODEL) ......................................................................... 4-35
4.6.1 RIGHT COVER (MF) ..................................................................................... 4-35
4.6.2 LEFT COVER (MF)........................................................................................ 4-38
4.6.3 FRONT COVER (MF) .................................................................................... 4-39
4.6.4 UPPER COVER (MF) .................................................................................... 4-41
4.6.5 REAR LOWER COVER (MF) ........................................................................ 4-42
4.6.6 REAR COVER (MF) ...................................................................................... 4-43
4.7 SMART OPERATION PANEL (MF MODEL) ............................................................. 4-45