Main Machine Installation (IM 430Fb)
D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1 2-22 SM
2.4 MAIN MACHINE INSTALLATION (IM 430FB)
This machine (Machine code: D0C4) is for installation by users. However, the customer
engineer must do the installation if the sales representative requests it.
2.4.1 ACCESSORIES
IM 430Fb (D0C4)
Description Q'ty
D0C4-17 D0C4-27
Power cord 1 1
Modular cable with ferrite core 1 -
Ferrite core - 1
Sheet - EULA (End User License Agreement) 1 1
Sheet - Note for Using This Machine Safely 1 1
Sheet - User Registration Sheet 1 -
Sheet - Note to the user (Caution for NFC Tag) 1 1
CD-ROM - Driver 1 1
Manual - Safety Information 1 1
Manual - Setup Guide 1 1
Manual - PRINTER LIMITED WARRANTY 1 -
Decal - Bluetooth 1 1
2.4.2 INSTALLATION PROCEDURE
Condensation may form inside the machine when it is moved from a cold location to a warm
location. Using the machine while condensation exists may cause a malfunction.
If condensation has formed, do not immediately turn on the power. Leave the machine, without
turning it on, in the location where it will be used for at least two hours. You can use the machine
when the room temperature and the temperature inside the machine are nearly the same.
If SC548 or the message for condensation appears on the control panel when you turn on the
machine's power, turn off the power and wait for the condensation to evaporate.
To Next Page
Loading...
