Ricoh SAVIN D0AP - Page 709

Printer SP Mode
SM 3-17 D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
SP Mode
Tables
MFP/Printer
1003 [Clear Setting]
1-003-001 Initialize Printer System CTL [- / - / -]
[Execute]
Initializes settings in the "System" menu of the user mode.
1-003-003 Delete Program CTL [- / - / -]
[Execute]
1004 [Print Summary]
Prints the service summary sheet (a summary of all the controller settings).
1-004-001 Print Printer Summary CTL [- / - / -]
[Execute]
1-004-002 Print Printer Summary2 CTL [- / - / -]
[Execute]
1007 [Supply Display]
Sets displaying remaining supply amount information or not.
0: Displays remaining supply amount information
1: Does not display remaining supply amount information
1-007-002 Drum CTL* [0 or 1 / 1 / 1/step]
1-007-006 Fusing unit CTL*
1110 [Media Print Device Setting]
1-110-002 0:Disable 1:Enable CTL* [0 or 1 / 1 / -]
1111 [All Job Delete Mode]
1-111-001 0:excluding New Job 1:including New Job CTL* [0 or 1 / 1 / -]
1112 [Supply End]
1-112-001 0:continue 1:stop CTL* [0 or 1 / 0 / -]
1121 [Introduction Setting Boot Mode]
(Only printer model)
1-121-001 0:Off 1:On CTL* [0 or 1 / 0 / -]
1400 [IPGL Setting]
(Only MF model)
1-400-001 Set Thin Line Width CTL* [0 to 99 / 5 / 1/step]