Ricoh SAVIN D0AP - Page 805

SP5-XXX (Mode) - Engine
SM 5-29 D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
SP Mode
Tables
MFP Only
SP No. Large Category Small Category ENG or
CTL
[Min to Max / Init.
/ Step]
5-804-179 Output Check Bank3 Feed CL ENG [0 to 1 / 0 / 1]
5-804-202 OUTPUT Check Scanner Lamp ENG [0 to 1 / 0 / 1]
5-810-001 SC Reset Fusing SC Reset ENG [0 to 1 / 0 / 1]
5-811-002 Machine Serial Display ENG* [0 to 255 / 0 / 1]
5-811-004 Machine Serial Set SCB ENG [0 to 255 / 0 / 1]
5-811-021 Machine Serial Update Latest ENG* [0 to 1 / 0 / 1]
5-811-022 Machine Serial Update Previous ENG* [0 to 1 / 0 / 1]
5-811-023 Machine Serial Previous ENG* [0 to 255 / 0 / 1]
5-811-024 Machine Serial Update Latest SCB ENG* [0 to 1 / 0 / 1]
5-811-025 Machine Serial Update Pre SCB ENG* [0 to 1 / 0 / 1]
5-811-026 Machine Serial Previous SCB ENG* [0 to 255 / 0 / 1]
5-894-001 ExternalCountSet SW Charge Mode ENG* [0 to 2 / 0 / 1]
5-900-001 Engine Log Upload Pattern ENG* [0 to 4 / 0 / 1]
5-900-002 Engine Log Upload Trigger ENG* [0 to 3 / 0 / 1]
5-930-001 MeterClick Charge Setting ENG* [0 to 1 / 1 / 1]
0: No
1: Yes
5-931-001 Life Alert Disp.
See NOTE below.
Maintenance Kit ENG* [0 to 1 / 1 / 1]
0: No
1: Yes
5-931-002 Life Alert Disp.
See NOTE below.
PCDU ENG* [0 to 1 / 1 / 1]
0: No
1: Yes
5-931-003 Life Alert Disp. PCDU STOP ENG* [0 to 1 / 0 / 1]
0: No
1: Yes
NOTE: - This is a setting to switch whether to display the alert. Also, it applies to whether
to send an NRS notification.
- This setting is valid when SP5-930-001 (MeterClick Charge Setting) is set to “1
(Yes)”.
- For the click model, this setting is configured to "0 (No)" before delivery.