Bit Switches – 2
SM 63 D0C5/D0C6/D0C4/D0AP FAX UNIT
(D0C5/D0C6
/D0C4/D0AP)
4 400 x 400 Super
Fine
The Resolution is set for "Bit 2 200 x 400.
5 600 x 600 Reserve
6 Reserve
7 mm/inch
This setting selects mm/inch conversion for mail transmission.
0: Off (No conversion), 1: On (Conversion)
When on (set to "1"), the machine converts millimeters to inches for sending mail. There is
no switch for converting inches to millimeters.
Unlike G3 fax transmissions which can negotiate between sender and receiver to
determine the setting, mail cannot negotiate between terminals; the mm/inch selection is
determined by the sender fax.
When this switch is Off (0):
• Images scanned in inches are sent in inches.
• Images scanned in mm are sent in mm.
• Images received in inches are transmitted in inches.
• Images received in mm are transmitted in mm.
When this switch is On (1):
• Images scanned in inches are sent in inches.
• Images scanned in mm are converted to inches.
• Images received in inches are transmitted in inches.
• Images received in mm are converted to inches.
I-fax Switch 02 (SP No. 1-102-003)
No Function Comments
0 RX Text Mail Header Processing
This setting determines whether the header information is printed with text e-mails when
they are received.
0: Prints only text mail.
1: Prints mail header information attached to text mail.
When a text mail is received with this switch On (1), the "From" address and "Subject"
address are printed as header information.
When a mail with only binary data is received (a TIFF-F file, for example), this setting is
ignored and no header is printed.
1 Output from Attached Document at E-mail TX Error
This setting determines whether only the first page or all pages of an e-mail attachment are
printed at the sending station when a transmission error occurs. This allows the customer to
see which documents have not reached their intended destinations if sent to the wrong
e-mail addresses, for example.
To Next Page
Loading...
