R&S FSL Power Measurements – MEAS Key
1300.2519.12 4.105 E-11
S
weep List
Opens a submenu to edit the sweep list and displays the Sweep List dialog box. After a preset,
the sweep list contains a set of default ranges and parameters. For each range, you can change
the parameters listed below. To insert or delete ranges, use the Insert before Range, Insert
after Range, Delete Range softkeys. The measurement results are not updated during editing
but on closing the dialog box (Close Sweep List softkey).
Note: If you edit the sweep list, always follow the rules described in "Ranges and range settings" on
page 4.81.
Parameter Restriction
Range Start
Range Stop
Filter Type
RBW
VBW
Sweep Time Mode
Sweep Time
Detector Spurious Emissions measurement only
Ref. Level
RF Att. Mode
RF Attenuator
Preamp
Sweep Points Spurious Emissions measurement only
Stop after Sweep Spurious Emissions measurement only
Transd. Factor
Limit Check 1 to 4
Abs Limit Start
Abs Limit Stop
Rel Limit Start Spectrum Emission Mask measurement only
Rel Limit Stop Spectrum Emission Mask measurement only
– Spectrum Emission Mask measurement:
The changes of the sweep list are only kept until you load another parameter set (via a preset
or by loading an XML file). If you want to have a parameter set permanently available, create an
XML file for this configuration (for details refer to "Format description of Spectrum Emission
Mask XML files" on page 4.83).
If you load one of the provided XML files (Load Standard softkey), the sweep list contains
ranges and parameters according to the selected standard. For further details refer also to
"Provided XML files for the Spectrum Emission Mask measurement" on page 4.82.
This softkey is available from firmware version 1.80.
To Next Page
Loading...
