SKF Microlog GX Series - Page 202

Run Up / Coast Down Module
Displaying Acquired Data
Note that even when more than 60 spectra are extracted, only 60 maximum will be
displayed in the waterfall plot. The 60 (or however many are specified) are selected
from the total set of spectra as follows:
• The first spectrum is always displayed.
• The last spectrum is always displayed.
• The other (specified number minus first and last spectrum) spectra are as evenly
distributed as possible through the set of spectra.
 You may view the "missing" spectra by performing the Z-axis
zoom feature detailed later in this section.
Trace Offset – (0
°
, 22.5
°
, 45
°
) - Specify the number of degrees to skew the waterfall
plot.
Figure 7 - 16.
Example Trace Offset Settings of 0
°
and 22.5
°
.
Trace Height – (Small, Medium, or Large) – Specify the height of waterfall spectra.
Figure 7 - 17.
Example Trace Height Settings of Small, Medium, and Large.
7 - 18 SKF Microlog - GX Series
User Manual